Hi all, I was a long term lurker on the other site and thought I'd take the opportunity of the change to raise my head
As one part of my business I mount artwork and prints for artists. This can, and often does, require cutting a number of different size pieces of board from a large single piece. Where the pieces required are standard sizes it's straight forward to plan the cutting to make the most of the board. Where I have more difficulty is when I have a number of non-standard sizes to cut. I need to work out the best way to lay them out to both maximise cost effectiveness and also to keep waste to a minimum (I Hate waste!).
So, DAK of any simple software that would work out the best way of cutting the board, given a set of required sizes and the standard size of the starting board?
Do ask if this makes no sense.
Got a credit card? use our Credit Card & Finance Calculators
Thanks to bruncher,niord,gvonge,Shelford,GrahamPlatt, for Donating to support the site
Layout software
Forum rules
Direct questions and answers, this room is not for general discussion please
Direct questions and answers, this room is not for general discussion please
-
- 2 Lemon pips
- Posts: 145
- Joined: November 8th, 2016, 8:32 am
- Has thanked: 24 times
- Been thanked: 38 times
-
- Posts: 35
- Joined: November 6th, 2016, 5:05 pm
- Has thanked: 7 times
- Been thanked: 12 times
-
- 2 Lemon pips
- Posts: 145
- Joined: November 8th, 2016, 8:32 am
- Has thanked: 24 times
- Been thanked: 38 times
Who is online
Users browsing this forum: No registered users and 2 guests